Shenyang Tengsheng plastic products factory strictly control the quality---suction nozzle
Shenyang Tengsheng plastic products factory strictly control the quality---suction nozzle
How to ensure the quality of products and reduce the yield of unqualified products is always an important goal of quality management.In order to strictly control the quality and deliver the standardized products to each customer, Tengsheng Plastic Packaging Co., Ltd. will irregularly conduct product quality training courses for the company's employees.
Quality standard for suction nozzle and cover
1. Appearance quality
(1) The cover is round and uniform in color.
(2) the outer wall of the cover is youdao reinforced ring, and the outer wall of the cover is densely covered with longitudinal anti-slip grain.
(3) No malformation cover.
(4) No pollution and damage on the surface of the cover, and no insect or mite pollution on the inner surface.
2. Internal quality
(1) Screw on the top of the bottle without cracking or slipping.
3. Specifications and dimensions
Staff product quality management
Inspection iii: Self-inspection, mutual inspection and special inspection
Inspection is a kind of inspection system which combines the self-inspection of operators, the mutual inspection between operators and the special inspection of full-time inspectors.
1. Starting from the procurement work: establish a strict raw material inspection system and work law, and do not accept defective products.
2. Production according to technical standards and process requirements: The technical department must put forward technical standards and process requirements, as well as relevant drawings before production, and organize all staff to study.Technical standards known only to technicians are meaningless standards.The wrong drawing is the most terrible defective product.
3. Implementation of product inspection support standards: good products are produced, not tested.But piecework management, quota management, if there is no production process quality inspection management, quality standards can not be effectively guaranteed.Irresponsible inspectors are the main cause of the defective products.
4. Process mutual inspection in the production process: go up to the responsible process -- no defective products are produced.Down to the responsible working procedure right - do not accept defective products.
5. Final packaging inspection: no delivery of defective products.If the defective products flow out of the factory for temporary benefits, then it is actually destroying the enterprise's job.
Three principles
1. Do not accept unqualified products
Non - acceptance of nonconforming product means that before the production and processing, the staff should check whether the products delivered before are qualified in accordance with the provisions. Once the problems are found, they have the right to refuse to accept and timely feedback to the prior process.The previous working procedure personnel should immediately stop the processing, trace the cause, take measures to timely find and correct the quality problems, and avoid the waste caused by the continuous processing of nonconforming products.
2. Do not manufacture unqualified products
Non-manufacturing of unqualified products refers to the acceptance of the previous qualified products, in the post of processing strict implementation of the operating standards, to ensure the processing quality of products.Check, confirm and other preparatory work before the operation is done in full place;Pay attention to the process of the operation at any time, avoid or early detection of the occurrence of abnormalities, reduce the probability of producing non-conforming products.Adequate preparation and confirmation in the process is the key to not manufacturing nonconformance.Only by not producing defective products can it be possible to avoid the outflow and acceptance of defective products.
3. No outflow of unqualified products
No outflow of defective products means that the staff shall complete the processing in this process and check and confirm the product quality. Once the defective products are found, they must stop the machine in time, cut off the defective products in this process, and complete the disposal of defective products in this process and take preventive measures.This process shall ensure that the delivery of qualified products will be rejected by the next process or "Customer".
